Setting "Note" not possible (Note=0)

[Stefan]

Hello,

1. I have wired a piezo to slot 36 HiHatE.
2. In the MegaDrumManager I set "Note=30".
3. I pressed "Send".
4. I trigger the piezo and the MegaDrumManager MIDI-Log tells "Note=0".

I think I had this kind of issue some days ago too. In the meantime it disappeared somehow, but I cannot remember how...And now it's back.

Does anyone have an idea?

Cheers,
Stefan

[dmitri]

Did you enable AltSamplingAlg? If so, disable it - there is a bug in it when Note is set 0 (disabled).

[Stefan]

Hi Dmitri,

No, it's not active. But anyways, I activated it and deactivated after.
The problem remains...

I have updated the picture in my first post to give you the full information.

[dmitri]

And you change Note/Alt/Note/Pressroll Note to 1 you see note 1 in the MIDI Log?
If so, post the whole .mds config here.

[dmitri]

And also, show all Notes that you configured on the HiHat Pedal.

[Stefan]

I set:
Note=1
Alt Note=1
Pressroll Note=1

the MIDI log says 0...

I will send to you the .mds-file.

[dmitri]

In the .mds you sent me all HiHat Pedal notes are set to 0. You don't have a pedal connected and properly configure and as a result MegaDrum thinks that the pedal is pressed so it uses notes from BowSO/EdgeSO/BellSO, BowHO/EdgeHO/BellHO, BowSCL/EdgeSCL/BellSCL and BowCL/EdgeCL/BellCL. See http://www.megadrum.info/content/hihat-pedal-settings

[airflamesred]

Do you need an actual hi hat on that input? If you just want to use it as a normal input then you can move it to a different input.

[Stefan]

That's it! I didn't see the "HiHat Pedal - Notes" section...

Thank you guys!

Stefan