megaDRUM freeze

[jfunkadams]

megaDRUm works great (made by Dmitri), but when I send configurations to the pads from megaDRUM manager the hardware stops receiving signals from my pads and must be restarted, the software continues to function as far as i can tell and does not need to be restarted, i simply close the midi and reopen it after restarting the hardware and it continues to show midi events

i've scoured the forum but haven't found a solution

i've tried half a dozen usb cables, two laptops (one with win7 and one with win8 both 64bit), on battery and plugged-in, and have the same problem

the firmware was updated successfully yesterday and is thus up to date

yes, i also get the green light after correctly setting midi I/O ports to megadrum usb midi

any advice is much appreciated!

[jfunkadams]

forgot to mention that i have also tried varying the sysEx delay from 10ms up to 500ms with same result

[jfunkadams]

resolved: note value must be set to value other than 0 when you make and send changes to any other values (i.e. threshold), a value of 0 on note value apparently disables that pad

hope this helps another newbie