www.megadrum.info

Hello,

I have noticed that every time I turn of my megadrum module (latest model 32 inputs, latest firmware) The positionnal channel reverts to 1, even tough I have saved the configuration with positional on snare. This is the only parameter that does that. All other are saved correctly and restored on power on. If I set it again it works fine for the snare, until I power off and then reverts to channel 1.

Anyone else run into this ?

Regards

I'll check it.

Thank you Dmitri, if I can help just tell me what to do

I just checked it and it works as it should. What is shown in PositionalIn in the Menu is a selected input for changing Positional settings (PositionalLv, PositionalLow, PositionalHi) that follow in the Menu. This way it minimizes navigation via Positional settings because Positional sensing can be enabled on all inputs.

Ok, that is clear now. Thank you Dmitri