Page 1 of 2
Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 05, 2017 3:26 pmby anus_young
Hello fellows,
I´m in trouble with hi hat settings, Tried to put the several notes into the Notes section that did not work.
Than I disabled them all except the hit trig and tip trig notes on Bow and Edge, because i´ve had read, that software is doing everything in between when cc4 is used?!
These are my settings actually:
Need help have only open hi hat can see that the md recognise my pedal movement, but do nothing in ez drummer.
My high level is about 740, Low is 16.
I can´t see a midi log window in MDM, is the reason that I have the 2,2 LCD?
Thanks in advance,
André
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 05, 2017 4:04 pmby dmitri
If you use MIDI CC for pedal positions then you have to set all HiHat Pedal Notes for all zones equal to Notes of the HiHat cymbal (not to zero!).
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 05, 2017 4:14 pmby dmitri
anus_young wrote:I can´t see a midi log window in MDM, is the reason that I have the 2,2 LCD?
In MDM select View->MIDI Log->Show.
Re: Cannot configure hall sensor hi hat cc4
Posted:
Mon Mar 06, 2017 1:03 pmby anus_young
Hello dmitri,
I tried this also without success. I´m now at work, but when I´m back at my mac than I will try this again. But the different Hi Hat states are total different named then in the MDM mask.
I will post screenshots for that, but my real issue is that MDM recognize the CC4 also EZDrummer2, too.
Regards,
André
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 12, 2017 11:15 amby anus_young
Hello Dmitri, seems to be a more technical problem instead of MDM, but let me show you the mdm screens for reversed and unchecked reversed levels. Looks like there is coming no signal thru from sensor to jack to md.
Would you think it´s better to post this in the off topic area?
Regards,
André
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 12, 2017 11:16 amby anus_young
Upps, pictures have to be declared opposite way sorry.
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 12, 2017 11:19 amby anus_young
Hello,
Here arme also pictures from the Sensor wiring.
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 12, 2017 11:20 amby anus_young
The magnet is aus usual underneath the footpedal.
Re: Cannot configure hall sensor hi hat cc4
Posted:
Sun Mar 12, 2017 8:35 pmby dmitri
What is the actual problem? You're not getting signal from the sensor? Check voltage on the signal wire with a voltmeter/tester. What voltage do you get when it's open and when it's closed? Btw, I myself never built a Hall sensor HiHat controller myself so if the problem is with the sensor then I'll probably won't be able to help.
Re: Cannot configure hall sensor hi hat cc4
Posted:
Wed Apr 19, 2017 10:47 amby maru_engineering
Hi,
Could you tell us the type of Hall Sensor you are using?