www.megadrum.info

Posted: **Mon Dec 10, 2007 7:08 am**

Hello Dimitri and the ohter members!

After I have build my box for the megadrum now I will start building the pcb's.

How to set the FUSEBITS in the AVR-CDC using AT MEGA 8 (USB/SERIAL-CONVERTER) ?

I found no informatiion about it.

You provide the AVR-CDC firmware, but no information if there is a need to set / change the AVR's FUSEBITS.

Thanks in advance

Popsel

Posted: **Mon Dec 10, 2007 9:48 am**

Use the same fuse settings as shown for Atmega8 based MegaDrum on the Documentation page

Posted: **Mon Dec 10, 2007 11:15 am**

Thank you very much.

Popsel

www.megadrum.info

Fusebit Settings for AVR-CDC (using AT MEGA 8)

Fusebit Settings for AVR-CDC (using AT MEGA 8)

Re: Fusebit Settings for AVR-CDC (using AT MEGA 8)

Re: Fusebit Settings for AVR-CDC (using AT MEGA 8)